Instructions 
Your VacBed will be shipped in several pieces for easy storage. It's a piece of cake to put it together, though, and should only take a few minutes.

Standard Bed Contents:

4 Pieces perforated pipe (all the same length)
2 Pieces perforated pipe (shorter than the others)
3 Corner connectors
1 T joint
2 Straight connectors
1 Latex envelope
1 Breathing tube

Choose a location for your VacBed. You can use it on any flat surface, but we suggest some sort of padding underneath so that the person in the bed will be comfortable. (You can place the VacBed on a blanket, rug, bondage table, or queen/king size bed, for example.) Make sure there are no staples, thumbtacks, pebbles, or other sharp, pointy, or metal objects under the bed, they'd be uncomfortable and could possibly injure the latex.

Lay out the pipes. The two shorter pieces go at the top and bottom of the bed. The longer pieces form the sides (2 per side). Place the T-joint in the corner corresponding to the vacuum hole in your envelope. Use the remaining connectors to construct the frame (corner connectors in the corners, and the straight connectors on the sides). The pipes will easily slip into the connectors.

Make sure that the perforations (small holes in the pipes) are aimed INWARDS. Slip the latex envelope carefully over your frame, being sure to pull the vacuum opening over the exposed T-joint.

Choose one of you to slide into the bed on your back. Stick the breathing tube out of the provided hole and place the other end in your mouth. The other player will zip the bed closed, insert the vacuum's hose into the T-joint and flip the vacuum's switch. In mere moments, the air will be sucked out of the bed leaving one of you in a delicious predicament! (And the other free to exploit it!)

A FEW IMPORTANT NOTES

Latex is fragile and can tear! Please take care when placing the frame within the envelope and when inserting the breathing tube. We are not responsible for any tears, rips, or holes caused by your usage.

Always play safely and make sure there are no obstructions to the breathing hole/tube. Please read our safety page for more information.

If for some reason you are not achieving full-suction, please make sure all pipes have their holes aimed inward. Make sure all pipes are pushed into their joints tightly. Make sure vacuum hose is securely within the T-joint. (If it's loose, try wrapping some tape around the vacuum's hose to tighten the fit.)